Table of Contents
Advertisement
FlameSpec IR3 User Manual
2 Installation
This chapter does not attempt to cover all of the standard practices and codes of
installation. Rather, it emphasizes specific points of consideration and provides some
general rules for qualified personnel. You must always observe special safety
precautions.
2.1 General Considerations
This section includes important information.
•
To help obtain optimal performance, the detector should be aimed toward the center of the
hazard or area to be monitored and protected ("detection zone") and have, to the extent
that is required, an unobstructed view of the protected area. Whenever possible, the
detector face should be tilted (aimed) down at an angle to prevent the accumulation of dust
and dirt.
•
Do not start an installation until the performance target, system configuration, installation
location and coverage considerations have been defined by the responsible person.
To ensure optimal performance the following guidelines should be addressed:
Sensitivity
To determine the sensitivity level, the following issues should be considered:
•
The size of the fire to be detected at the determined distance.
•
The type of flammable fuel.
•
Potential sources of false alarms that may be present (e.g., naked flames, hot process).
Spacing and Location
Consider the following factors when determining the number of detectors and their
locations in the protected area:
•
The size and shape of the protected area
•
The nature of the hazards, including materials stored or used and the protected objects
•
The sensitivity of the detectors
•
If there are any obstructed lines of sight
•
The field of view of the detectors (See Figure 9 and Figure 10)
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com
F120V0020.07
7
Advertisement
Table of Contents
