Safety Instructions - HSM StoreEx HDS 230 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

english

1. Safety instructions

DANGER
Warns of an imminently hazardous situation
that can lead to death or serious injury if not
avoided.
WARNING
Warns of a hazardous situation that can result
in death or serious injury if it is not avoided.
CAUTION
Warns of a hazardous situation that can result
in
minor injuries or property damage if it is
not avoided.
NOTE
Indicates information for the eff ective operation
of the device without the risk of danger.
General safety instructions
NOTE
• Read through the operating
manual carefully before initial
start-up of the device, and pay
attention to the safety instruc-
tions.
• Store the operating manual for
later use and keep it close to
the device.
• Pass the manual on to the
new owner in the event of a
change of ownership.
CAUTION
Endangered persons
The device must not be
operated by:
• Children (under 16 years)
• People with limited physical,
sensory or mental capabilities
• People with a lack of experience
and knowledge.
16
StoreEx HDS 230
DANGER
Risk of electric shock
Improper handling of the device
can lead to electric shocks.
• Check the device and the cable
for damage before use.
• Switch the device off if it is
damaged or not working cor-
rectly and before relocation,
maintenance or cleaning,
and also disconnect the power
plug.
• Never remove the power plug
from the socket by pulling on the
power supply cable.
• Do not touch the power plug with
wet hands.
• Do not allow water from
penetrating the device.
WARNING
Risk of injury from
the cutting unit
Cutting injuries are possible be-
cause of the sharp cutting unit.
• Wear protective gloves when
removing blockages.
WARNING
Warning from being pulled in
Risk of being pulled during
cutting unit operation.
• Keep hair, clothing, scarves, ties
and body jewellery away from
the infeed slot area.
• Do not shred any material
that may become tangled (e.g.
tapes, tie fasteners or soft plastic
fi lm).
09/2021

Advertisement

Table of Contents
loading

Table of Contents