Installation; Telephone Operation - Northwestern Bell 20200 Owner's Manual

INSTALLATION

Desktop Use
1. Set the unit on the selected desktop
and connect the telephone line cord
to the telephone line jack on the rear
of the base unit.
2. Connect the opposite end of
telephone line cord to the telephone
modular wall jack.
3. Connect one end of the coiled
handset cord to the handset jack of
the base unit (located on the left
hand side of the base) and the other
end to the handset jack of the
handset.
Wall Use
(with a standard AT&T or GTE modular wall jack)
1. Connect the short telephone line
cord to the telephone line jack on
rear of the base unit.
2. Connect the opposite end of the
short telephone line cord to the
telephone modular wall jack.
3. Align the wall mounting slots with
the studs located on the modular
wall plate and slide the base down
to lock in place. See figure 1.
Base Unit
Telephone
(Side View) Modular Wall
Jack
Wall Mount
slots
(Figure 1)
NOTE: If you do not have a standard
modular wall jack, have a qualified
technician mount one on the wall.
7
OWNER'S MANUAL #
Page: 7
Handset Retainer Tab Installation
If the base unit is to be placed in the wall
mount position, the handset retainer tab
must be pulled out, turned around and
placed in the opposite direction, so that
the tab allows the handset to hang onto
the base unit, as shown in figure 2

TELEPHONE OPERATION

Dialing Mode (TONE/ PULSE Switch)
Pulse > Tone (Mixed Mode) Dialing
If you only have a pulse (rotary) dialing
service in your area and want to access
Studs
tone dialing services, set the PULSE/
TONE switch to the PULSE position.
Before dialing the desired number upon
Modular
picking up the handset, press the TONE
Wall
button once. You can then access tone
Plate
dialing services while using a pulse
dialing system.
Adjusting the Ringer Volume
You can adjust the ringer volume from
low to high by rotating the RINGER
VOLUME control, located on the side of
the unit.
NOTE: If you decrease the ringer
volume, always remember to return the
20200 ver.
ENGLISH VERSION
(Figure 2)
If your home is equipped with tone
dialing service, set the TONE/
PULSE switch to TONE position.
If you have a pulse(rotary) dialing
service, set the TONE /PULSE
switch to PULSE position.
07069A
07069A
Handset
Retainer Tab