Table of Contents
Advertisement
since these can damage the finish.
2.
Your phone should be situated away
from heat sources such as radiators,
heaters, stoves or any other appliance
that produces heat.
INSTALLATION
PRECAUTIONS
1.
Never install telephone wiring during a
lightning storm.
2.
Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
3.
Never touch uninsulated telephone
wires or terminals unless the telephone
line has been disconnected at the
network interface.
4.
Use caution when installing or
modifying telephone lines.
CAUTION
To reduce the risk of fire or injury to persons,
read and follow these instructions:
1.
Use only the battery(ies) specified in
this manual.
2.
Do not dispose of the battery(ies) in a
fire. The cell may explode. Check with
local codes for possible special disposal
instructions.
3.
Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and
may cause damage to the eyes or skin.
It may be toxic if swallowed.
4.
Exercise care in handling the battery(ies)
in order not to short the battery with
conducting material such as rings,
bracelets and keys. The battery or
conductor may overheat and cause
burns.
5.
Do not attempt to recharge the
battery(ies) provided with or identified
for use with this product. The
battery(ies) may leak corrosive
electrolyte or explode.
6.
Do not attempt to rejuvenate the
battery(ies) provided with or identified
for use with this product by heating
them. Sudden release of the battery
electrolyte may occur causing burns or
irritation to eyes or skin.
7.
When replacing the batteries, all the
3
batteries should be replaced at the same
time. Mixing fresh and discharged
batteries could increase internal cell
pressure and rupture the discharged
batteries.
8.
When inserting the battery(ies) into this
product, the proper polarity or direction
must be observed. Reverse insertion of
batteries can cause charging, and that
may result in leakage or explosion.
9.
Remove the battery(ies) from this
product if the product will not be used
for a long period of time (several
months or more) since during this time
they could leak in the product.
10. Discard the "dead" battery (ies) as soon
as possible since "dead" batteries are
more likely to leak in a product.
11. Do not store this product, or the battery
(ies) provided with or identified for use
with this product, in high-temperature
areas. Batteries that are stored in a
freezer or refrigerator for the purpose of
extending shelf life should be stabilized
at room temperature prior to use after
cold storage.
12.
Disconnect telephone lines before
installing batteries.
INDUSTRY CANADA
CERTIFIED
RINGER EQUIVALENCE NUMBER
NOTICE: The Ringer equivalence number
(REN) assigned to each terminal device
provides an indication of maximum number
of terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the ringer equivalence numbers of
all the devices does not exceed 5.
INDUSTRY CANADA NOTICE
NOTICE: The Industry Canada label
identifies certified equipment. This
certification means that the equipment
meets certain telecommunication
network protective, operational and
safety requirements. The Department
010508A-1
- Quick Links:
- Telephone Operation
Hide quick links:
Advertisement
Table of Contents
