Table of Contents
Advertisement
PRODUCT ASSEMBLY (CONTINUED)
INSTALLING THE JULIENNE DISC
1.
Insert the Liner into the Attachment Assembly so that the Feed Tubes line up and the Liner
lies flat.
2.
Slide the Disc Adapter onto the Drive Pin.
3.
Hold the Julienne Disc by the two finger grips, with the smaller side of the middle hole
facing up. Install the Disc on the Disc Adapter by fitting the Adapter through the hole in the
bottom of the Disc until it is seated against the Liner.
4.
Install the Lid by turning counterclockwise, being sure it locks into place.
INSTALLING THE ADJUSTABLE SLICING DISC
1.
Insert the Liner into the Attachment Assembly so that the Feed Tubes line up and the Liner
lies flat.
2.
Hold the Slicing Disc by the finger grips and lower it onto the Drive Pin. You may need to
turn the Disc/Drive Adapter until it drops down into place.
3.
Set the desired slicing thickness by moving the External Control Lever to the left for thinner
slices or to the right for thicker slices.
NOTE: If the sliced food is not to the desired thickness, the External Control Lever can be
adjusted during operation.
4.
Install the Lid by turning counterclockwise, being sure it locks into place.
INSTALLING THE DICING DISC AND BLADE
1.
Insert the Liner into the Attachment Assembly so that the Feed Tubes line up and the Liner
lies flat.
2.
Hold the Dicing Disc by the middle hole and Disc edge, chute lip side facing down. Place
the Disc on top of the Liner so that the dicing grate aligns with the Liner's Feed Tube.
6
A
B
A. Disc Adapter
B. Drive Pin
Advertisement
Table of Contents
