Installing The Adjustable Slicing Disc - KitchenAid KFP1355 Instructions Manual

ASSEMBLING THE FOOD PROCESSOR
Place the dicing kit lid on the work bowl
5
with the feed tube just to the left of the
work bowl handle. Grasp the feed tube
and turn the cover to the right until
it locks into place.

Installing the adjustable slicing disc

IMPORTANT: The adjustable slicing disc can only be installed in one direction.
Drop the drive adapter over the
1
power shaft.
TIP: You may need to adjust the drive
adapter with a slight turn on the power
shaft until it drops into place.
Drop the assembled disc onto the drive
3
adapter and check to make sure it is
firmly in place.
12
After dicing, remove the work bowl
6
cover and dicing blade, then insert the
dicing kit clean out tool into the dicing
kit base, and fold down to push any
extra food through the grid.
Use the finger holes to hold the top of
2
the adjustable slicing disc. Align the pins
on the slicing adapter with the L-slots
on the bottom of the disc. Turn to lock
into place.
Install the work bowl cover, being sure
4
it locks into place.