Bay Networks 5393 User Manual page 62

Release 5.1 Supplement for Remote Annexes
119346-A Rev. A
44
Table 3. SPB Field Definitions (continued)
Field Definition
rate56k If set to yes, specifies a data rate of 56 Kb/s for the B
channels, even if the bearer information in the incoming
ISDN SETUP messages indicates a different rate. The
default is no, which sets the data rate to the rate provided in
the SETUP message. Do not change this default unless you
are in Europe or Australia and are having problems
receiving calls from the U.S. In this situation, the telco
sometimes fails to specify the correct data rate. In all other
situations, specify no.
set Specifies a port parameter setting that is applied to the
session. The syntax is:
set [parameter parameter_value]
You can specify multiple set commands. These settings
override the values in nonvolatile memory while the session
is active, but they do not change the actual values in
nonvolatile memory. Any parameters not specified in set
fields are determined by the actual global (nonvolatile
memory) settings.
end_session Mandatory; ends the SPB.