ION 30ACi Operation Manual page 9

30ACi
Battery Back-Up System
ii. Push up on the sensing plate through
the center hole on the underside of the
switch. Note that, being an electronic
switch, you will not hear a clicking
sound.
iii. If the pump does not turn on, the switch
may have to be replaced.
iv. If the pump does turn on, continue to
the next step.
c. Verify the range of the switch. Your system
should have been supply with a 6" range
switch.
i. See Page 5, Figure A to verify that the
On level is appropriate for your basin.
1. If the On level is too high, contact
the installer.
w voId
arranty IS
1. Using an extension cord.
2. Any power cord has been cut or the grounding
prongs removed or using an adapter fitting.
3. Inverter has been used in an outdoor
application.
4. Batteries not meeting the above specifications
have been used.
5. Inverter has been submerged in water.
6. Inverter has been tampered with in any manor
not described in the above instructions.
7. Working on the inverter, pump or switch while
plugged in.
8. Inverter has been disassembled by customer.
9. Inverter has been applied to products exceeding
the maximum capacity of the inverter, i.e., a
pump other than the one supplied with the unit
or more than one pump.
10. Inverter has been applied to the wrong voltage.
11. Removing motor housing, unscrewing impeller,
...
If
OPERATION MANUAL
Dated: 07/23/2013
Document Name: 30ACi_OM
or otherwise removing impeller seal of pump.
12. Running the pump continuously.
13. Pumping chemicals or corrosive liquids.
14. Pumping gasoline or other flammable liquids.
15. Any tags or labels have been removed from
the inverter, pump or Ion
switch.
Register your product at www.sumpro.com
Page 9 of 12
Digital Level Control
™