Tools Needed; Installation - ION 30ACi Operation Manual

30ACi
Battery Back-Up System
t S
echnIcal pecIfIcatIonS
Inverter Specifications
Mains A.C. Lower Voltage Limit
Output Voltage with Full Load
Battery Lower Voltage Limit
Output Frequency
Main Output Frequency
Battery Charger Boost Voltage
Overload
Pump Specifications
Output
Discharge
Model
HP Amp
WC-33 1/3 4.0 1-1/2 NPT
t n
oolS eeded
A pipe wrench, insulated pliers, insulated adjustable
wrench, and insulated screwdriver will be needed.
I I
nStallatIon nStructIonS
Remove all packaging from the box. It should include:
an inverter, battery box, pig tail with Anderson
connector, inverter power cord and pump with Ion
switch.
Find a suitable place to set the unit. Keep in mind that
the unit should be placed in an area where water and
moisture will not splash or drip on the unit, the fan inlet
on the sides of the enclosure will not be obstructed
and where a properly grounded three prong dedicated
receptacle is within reach of the power cord.
• Remove watches, rings, or other metal objects.
• Use tools with insulated handles
• Do not lay tools or metal parts on top of batteries
1. Install the 12 volt deep cycle marine battery
Register your product at www.sumpro.com
90 VAC ± 5V
110 - 120V ± 10 V
10.5 VOC ± 0.2 V
Same as Input
13.7 ± 0.2 V
130% ± 3% (With Auto
Reset Function)
Rated
(inch)
Head (feet) Flow (GPM)
10
OPERATION MANUAL
Dated: 07/23/2013
Document Name: 30ACi_OM
Pump Performance Curve
30
25
20
15
10
5
0
0 5 10
Maximum
Head Flow (GPM)
41 0 GPM @ 24' 46 GPM @ 0'
into the plastic battery box. Make sure that the
MCB (main circuit breaker) on the back of your
inverter is in the OFF position.
2. Connect the black negative (-) wire of the pig
tail to the negative (-) terminal of the 12 volt
battery.
3. Connect the red positive (+) wire of the pig tail
to the positive (+) terminal of the 12 volt battery.
4. Lay wires on over the short side of the battery
box so the Anderson connector is on the outside
®
of the battery box. Install the plastic cover on
the battery box so that the red and black wires
come out of the battery box and set the inverter
on top of the battery box cover.
5. Plug the Anderson connector from the inverter
into the Anderson connector from the battery,
insuring that the wire colors match on both
sides.
6. Install the sump pump in the sump pit and place
the sump cover back on the sump pit so that
the pump switch cord and pump power cord
reach the inverter.
7. Plug the switch cord into the back of the inverter
Page 4 of 12
15 20 25 30 35
Capacity - US GPM
Dimensions
L x W x H
9 x 6-1/2 x 10"
40 45
Weight
(lbs)
18