Remote Unit Name - Bay Networks CLAM Supplementary Manual

EXP+BKUP means that when Demand Threshold values are
met (see below), packets defined as EXPEDITEd in the Type
Filter Table will be sent by the first additional link dialled up.
It also allows the use of the BACKUP facility to dial the
Remote Unit Name destination (see below) if the usual link
fails.
NON-EXP.DATA means that when Demand Threshold
values are met (see below), packets defined as NON-
expedited in the Type Filter Table will be sent by the first
additional link dialled up.
NON-EXP+BKUP means that when Demand Threshold
values are met (see below), packets defined as NON-
expedited in the Type Filter Table will be sent by the first
additional link dialled up. It also allows the use of the
BACKUP facility to dial the Remote Unit Name destination
(see below) if the usual link fails.
REMOTE The name or ISDN number of the remote partner bridge,
UNIT NAME unless the Backup/Demand Mode parameter is set to NONE.
Note: the name must be configured in the ISDN Numbers
configuration table.
BACKUP Another bridge's dial-up ports may be used to BACKUP this
BRIDGE port. This provides 1-for-N backup of leased lines connected
to a number of bridges. The value specifies the MAC address
of the bridge used to place the backup call (which must be on
the same LAN).
Note: Bandwidth on Demand circuits can only be dialled up
from the same unit as the port requesting the additional
bandwidth. Dialup bandwidth by another bridge can only be
used for circuit backup purposes, i.e. when the original
circuit has failed.
A
DDENDUM
Page 5