————— Instruction Manual —————
Stationary Structure
Models: PKG46STRG(4'-6'), PKG68STRG(6'-8'), PKG82STRG(8'-12')
Item
Qty
Description
A
2
Extension Frame and Telescoping Extensions
B
3
Wall Boards
C
2
Chain Eye Brackets
D
2
3/16" Proof Chain
E
12
Flanged Elevator Bolt
F
20
3/8" Hex Nut
G
28
3/8" Flat Washer
H
20
3/8" Lock Washer
I
4
3/8" x 2" Hex Bolt
J
4
3/8" x 2 1/2" Hex Bolt
K
4
Saddle Clamp Half
Wall mount structures require a minimum ceiling and wall height as well as an acceptable wall mounting
surface. Brick, block, or poured concrete walls are superior. It is inadvisable to mount structures to walls
with wood or steel studs unless additional work approved by an engineer is done to provide additional
support. Bison does not provide wall anchors with any structure. The purchaser assumes liability for
the installation of any wall mounting structure. Consult a professional architect, engineer, or contractor
to determine safe methods of installation to your facility's wall construction.
All assembly material are supplied except hardware to attach the wall board to the customer's wall.
Attachment method and type of anchor used are the responsibility of the installer.
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
Read all instructions before proceeding.
1. Using a hammer, install the Flanged Elevator Bolts (E) into the back of each wall board in the
holes indicated in Figure 1.
Date: 05/10/21
Rev: 11
In Stock
CAUTION!
B.A.
N.J.C.
Item
Qty
Description
L
1
1/4" Allen Wrench
M
8
7/16" x 1 1/2" Carriage Bolt
N
8
7/16" Flat Washer
O
8
7/16" Lock Washer
P
8
7/16" Hex Nut
Q
2
Turnbuckle
R
2
Chain Connector Bracket
S
2
Chain Connector
T
1
Rim (packaged separately)
U
1
Backboard (packaged separately)
V
1
Backboard Padding (packaged separately)
NOTE:
File:
ST Series.pub
Customer Service
(800) 247-7668
Ref#: 950159