Advertisement
7.
Attach the lower Extension Frame (A) to the lower Wall Board (B) as outlined in step # 5. You may
need to support this Extension Frame Assembly (A) until the backboard is attached.
8. Adjust the Telescoping Extensions (A) so they are the same distance from the wall and the proper
distance for wall to face of backboard positioning.
9. Mount the backboard to the structure. For use with Bison BA42XL Backboard, the 7/16" Hardware
(M-P) is required. Some backboards might require hardware not provided with this unit. Make sure the
backboard is level.
Failure to have all mounting plates in the same plane will create stress on the backboard and may result in
breakage of glass backboards before, during, or after play begins.
10. When you are confident that the board is level, the proper distance from the wall and there is no stress
on the backboard due to misalignment tighten all the set screws with the 1/4" Allen Wrench (L). Drill
3/8" holes at the pilot holes on both frames and secure with 3/8" X 2 Hex Bolts (I), 3/8" Lock Washers
(H), and 3/8" Hex Nuts (F). See Figure 5.
11. Mount the rim and net insuring that the rim is 10' from the playing surface and level.
12. Check to insure that all bolts are tight. When all the steps are complete, remove excess chain using a
bolt cutter or hacksaw.
13. Install Backboard Padding (V) using the hardware and instructions provided with the padding
14. Do not allow play until you are confident the structure is securely mounted to the wall. The structure
must be capable of supporting 1000 lbs. to be considered safe for play.
FIGURE 5
FIGURE 5
Drill a 3/8" hole at the pilot
hole and insert 3/8"bolts (I), lock
washers (H), and nuts (F)
WALL MOUNTED STRUCTURES SHOULD BE CHECKED
YEARLY FOR LOOSE BOLTS OR ANCHORS.
Warning!
(4 Places inside)
Note:
5
Backboard
Not Shown
Backboard Mounting
Plate
Advertisement
