Configuration Default; Unit Reboot; Configuration Dump - Bay Networks CLAM Reference Manual

Nautica CLAM Bridge Reference Guide

Configuration Default

Unit Reboot

Configuration Dump

3-2
The current SAVEd configuration can be defaulted by typing CO
STD from any menu. You will be prompted to confirm the action:
Y will cause the unit to erase the SAVEd configuration, and
reboot with the default configuration.
Typing REBOOT makes the unit reset itself. Having confirmed
the action, any configuration changes not saved will be lost as the
unit resets itself and the stored configuration is loaded.
The curent SAVEd configuration of the unit can be dumpted from
the Manager. This configuration is in human-readable format
(except for passwords), and may be used for comparison with
other installations. configurations may also be loaded and run via
the management interface.
Typing DCONFIG from any menu causes the current SAVEd
configuration to be output to the terminal logged in as the
Manager. The screen will pause before dumping the
configuration. If a record of the configuration is required, the
attached terminal should have Capture Mode turned on. Then
press the <Space> bar to start the configuration dump.
After the dump is complete, terminate the file capture and press
the <Space> bar again to return to the menu system.
302975-A Rev.00