Nortel Digital Telephone IP Adapter Quick Start Manual
Nortel meridian digital telephone ip adapter telephone adapter: quick start
Hide thumbs
Also See for Digital Telephone IP Adapter:
- Release note (27 pages) ,
- Installation and administration manual (262 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Nortel Digital Telephone IP Adapter
Summary of Contents for Nortel Digital Telephone IP Adapter
- Page 1 Standard 1.1...
- Page 2 Users must take full responsibility for their applications of any product specified in this document. Printed in Canada. NORTEL is a registered trademark of Nortel. Microsoft and Windows NT are registered trademarks of Microsoft Corporation. All other trademarks and registered trademarks are the property of their respective owners.
- Page 3 Standard 1.1 Congratulations on your purchase of the Digital Telephone IP Adapter unit. Your new Digital Telephone IP Adapter unit gives you the advantage of low cost long distance internet telephone calls. There are two kinds of Digital Telephone IP Adapter units: •...
- Page 4 Standard 1.1...
- Page 5 Standard 1.1 You need a 10BaseT Ethernet cable to provide the Digital Telephone IP Adapter units with voice over IP capability. For instructions on how to install the Digital Telephone External IP Adapter unit turn to unit” on page You need the following tools to install the Digital Telephone Internal IP Adapter unit in your Meridian (M2000 series) digital telephone: •...
- Page 6 Standard 1.1 Secure the circuit card to the footstand with the two screws provided. Plug the 18 cm (7 inch), TCM cable into the RJ-11 jack on the telephone (the other end is attached to the Internal IP Adapter circuit card). Re-attach the footstand to the bottom of the telephone (2 screws).
- Page 7 RJ-45 plug on the Digital Telephone IP Adapter unit. Connect the Digital Telephone IP Adapter unit to the power source as follows: Connect the plug on the power transformer to the POWER connector on the Digital Telephone IP Adapter unit.
- Page 8 Standard 1.1 As soon as you connect the Digital Telephone IP Adapter unit to the power source, the unit begins to power up and the power LED comes on. The power-up cycle takes about 30 seconds to complete. When the Digital Telephone IP Adapter...
- Page 9 Standard 1.1 You can configure the Digital Telephone IP Adapter unit through the telephone set. Before you begin, your System Administrator must supply you with a completed Digital Telephone IP Adapter telephone menu — Configuration Values form. Use the information provided on this form to configure the Digital Telephone IP Adapter unit.
- Page 10 Release (Rls, R, or Goodbye depending on your telephone set) key once. After installing the Digital Telephone IP Adapter unit and powering up: Press the Release key four times within three seconds to access the telephone menu.