Removing The Monitor Base - Compaq 1825 User Manual

Removing the Monitor Base

You can remove the monitor base to mount the monitor on a wall,
a swing arm or other mounting fixture. To remove the monitor
from the base, read the caution and warning below before
beginning the procedure.
CAUTION: Before beginning to disassemble the monitor, be sure
Ä
the monitor is turned off and the power and signal cables are both
disconnected.
Lay the front bezel down on a soft area to prevent it from getting
scratched, defaced, or broken
WARNING: Do not remove the base from the monitor while the
Å
monitor is in the upright position. Before removing the monitor from
the base, ensure that the monitor is lying flat, front bezel down, and
that the base is set to the maximum base extension. Attempting to
remove the monitor from the base while upright in the minimum base
extension may result in injury to the user.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
User's Guide
1825 flat Panel Monitor
7