Table of Contents
Advertisement
MN009326A01-AA
Chapter 10 : Man Down (Fall Alert)
Chapter 10
Man Down (Fall Alert)
The Man Down feature (henceforth known as Fall Alert) enables your radio to alert others when you
are in danger.
If your radio tilts at a specified angle, is stationary for a time, or tilts and is stationary, it prompts an
Alert Tone. If you do not respond to the prompt before the predefined reminder timer expires, your
radio automatically sends an Emergency Alarm or Emergency Call, skipping the 3 seconds countdown.
To prevent your radio from sending an Emergency Alarm or Emergency Call, you can take the
following measures:
•
For Tilt Alarm, you must restore the radio to the vertical position. You may configure the threshold
for the tilt angle detection of the radio to 30°, 45°, or 60°, with the default angle setting as 45°.
•
For No Movement Alarm, you must move your radio. You may configure the threshold to high,
medium, or low sensitivity, with the default setting set to medium sensitivity.
•
For Tilt and No Movement Alarm, you must restore the radio to the vertical position or move it. Both
threshold settings for Tilt and No Movement will take effect for the Tilt and No Movement Alarm.
Either thresholds may trigger the man down event.
If any of the configured thresholds are exceeded consistently for the default pre-alarm timer duration of
100 seconds, you radio shows the following indications.
•
A tone sounds.
•
The red LED blinks for the default alarm timer duration of 10 seconds.
NOTE: Both the pre-alarm timer and the alarm timer are configurable by using the Wave
OnCloud (WoC) portal from 1 to 3600 seconds.
36
Advertisement
Table of Contents
