Westinghouse iGen2550 User Manual page 11

COMPONENTS
MUFFLER AND SPARK ARRESTOR
The spark arrestor prevents sparks from exiting the
muffler. It must be removed for servicing.
NOTICE
device that prevents sparks from exiting the muffler
and creating a fire hazard. In certain locations
a spark arrestor may be required by law. It is the
operator's responsibility to know and follow all
local laws and regulations related to fire prevention
requirements.
OIL DIPSTICK
Unscrew the oil dipstick to check oil levels and add oil
when needed.
OUTPUT READY LED
Illuminates when the generator is operating normally.
Indicates the generator is producing electrical power at
the receptacles.
OVERLOAD LED
Indicates that the generator is overloaded.
OVERLOAD RESET
The generator will automatically switch OFF all AC
output to protect the generator if overloaded or if there
is a short circuit in a connected appliance.
PANEL LIGHTS ON/OFF BUTTON
Depress this button to turn the lights on both sides of
the panel on and off.
PARALLEL OPERATION OUTLETS
A parallel cord (not included) can be used to connect
a compatible Westinghouse inverter generator for
additional power output.
RECOIL HANDLE
Use the recoil handle (and the engine/fuel control
switch) to start the generator.
SPARK PLUG SERVICE DOOR
Lift the spark plug service door to access the spark
plug.
The spark arrestor is a safety
FIG. 5
A
N
K
L
M
A - 120 Volt AC 20 Amp Receptacles
B - 120 Volt AC 30 Amp Receptacle
C - Parallel Operation Outlets
D - ECO Mode Switch
E - Reset Button
F - 20 Amp Circuit Breaker
G - USB Ports
H - Panel Lights On/Off Button
I - 30 Amp Circuit Breaker
J - Ground Terminal
K - Low Oil LED
L - Overload LED
M - Output Ready LED
N - Data Center
USB PORTS
Two-port 5V/2.1A USB outlet. Accepts Type A USB
plugs.
VENTED FUEL CAP
The fuel cap has a vent that can be opened and closed.
The vent should be open when the engine is running
and closed when the engine is off.
C
B
D
J
English | 11
E
F I
H
G