Mount Radiator On Horizontal Surfaces; Secure The Radiator With A Safety Cord; Integrus Receivers; Integrus Charging Units - Bosch INTEGRUS User Manual

INTEGRUS
5.2.6

Mount radiator on horizontal surfaces

When the radiator has to be positioned a horizontal surface (e.g. on top of an interpreter
booth), the distance between the radiator and the surface must be at least 4 cm (1.5 inch) to
enable enough air flow around the radiator. This can be achieved by using the suspension
bracket as a support. If this is not possible, switch the radiator to half power. If the radiator is
used at full power on top of an interpreter booth, the ambient temperature must not exceed
35° C.
5.2.7

Secure the radiator with a safety cord

The radiator is supplied with a safety eye to secure the radiator with a safety cord (not
supplied).
Note: It is mandatory to use the safety cord.
1.
2.
3.
Warning!
Only individuals who have a thorough knowledge of the techniques and regulations of rigging
objects overhead can suspend any objects. When suspending radiators, always take into
account all current national, federal, state and local regulations.
!
It is the responsibility of the installer to ensure that the radiators are safely installed in
accordance with all such regulations. If the radiators are suspended, the installation must
inspected at least once a year. Take remedial actions immediately if any sign of weakness or
damage is detected.
5.3

Integrus receivers

The infrared receivers can operate with disposable batteries (2x AA-size alkaline cells) or with
a rechargeable battery pack (LBB 4550/10).
Insert the batteries or the battery pack in the receiver with the correct polarity as indicated in
the battery compartment. The battery pack has a separate connection cable which must be
connected to the receiver. When this connection is not present, the charging circuitry in the
receiver will not work. This also prevents the unwanted charging of disposable batteries. The
battery pack has a temperature sensor which prevents overheating during charging.
For more information about charging the battery pack see section Integrus Charging Units.
Notice!
i
Disposable batteries and battery packs at the end of their technical lives should be discarded
with due care for the environment. When possible, take batteries to a local recycling station.
5.4

Integrus Charging Units

Mount charging cabinet on a wall
The LBB4560/50 is suitable for wall-mounted use.
Bosch Security Systems B.V.
Mount the safety eye properly in the hole of the radiator.
– Make sure that the minimum strength of the safety cord, of the mounting material, of
the shackle, and of the supporting building structure can withstand 1.500 N.
– Make sure that the length of the safety cord is not more than 20 cm longer than
needed.
Mount the safety cord in the safety eye.
Mount the safety cord in the supporting building structure.
User manual
Installation | en 37
2023-01 | V01 |