Bosch INTEGRUS User Manual page 12

12 en | System overview
Rear view
1
2
3
The LEDs next to the network connectors share the same behavior:
–
–
–
–
4
5
6
7
8
9
10
2023-01 | V01 |
1 2 3
Power supply.
Network 1: Supports powering through DICENTIS or PoE.
Network 2: Supports powering through DICENTIS.
Red/green or amber/green blinking: The transmitter needs to be upgraded.
Yellow: Network activity present.
Green: Network speed of 1 GB.
Orange: Network speed of 100 MB.
HF In: Slave input. BNC connector that accepts an HF signal from a transmitter in
Master mode.
Mode Master/Slave switch. The default mode is Master.
HF Out 1-6: Six high-frequency BNC connectors, used to connect to the radiators. Up to
30 radiators can be connected in a loop to each output.
Reset button: Press and hold for 10 seconds to reset the device to factory settings.
Emergency terminal block socket for distribution of emergency messages to all
channels.
Audio In: XLR socket distribute audio to all channels.
Chassis ground.
5
4
User manual
6 9
7
8
Bosch Security Systems B.V.
INTEGRUS
10