Mount Radiator On A Floor Stand; Mount Radiator On A Wall - Bosch INTEGRUS User Manual

INTEGRUS
5.2.3

Mount radiator on a floor stand

Figure 5.5: Attaching the stud of a floor stand to the suspension bracket of the radiator
Figure 5.6: Attaching the radiator inclusive suspension bracket and stud to the floor stand
The top of the floor stand is screwed into the suspension bracket (see previous figure). The
bracket is supplied with both metric and Whitworth threaded plates, and is therefore
compatible with most standard floor stands. For floor stands, the minimum installation height
must be 1.80 m, and the mounting angle can be set at 0°, 15° or 30°.
5.2.4

Mount radiator on a wall

For wall mounting, the minimum installation height must be 1.80 m, and an extra wall bracket
(LBB 3414/00) is required (must be ordered separately). This bracket is attached to the wall
by means of four bolts (see the next figure).
Figure 5.7: Attaching the wall mounting bracket to a wall
Notice!
i
The four bolts used to attach the bracket must each be able to withstand a pull-out force of
200 kg (440 lb). The bolts and plugs delivered with the LBB 3414/00 wall bracket are only
intended for mounting the unit on a solid brick or concrete wall.
Four holes of 10 mm in diameter and 60 mm in depth must be drilled using the drilling pattern
(see the next figure).
Bosch Security Systems B.V.
User manual
Installation | en 35
2023-01 | V01 |