Degelman HY-ROLLER Quick Start Manual

QUICK-START GUIDE
HY-ROLLER
for
* Refer to operators manual for complete safety and operation info.
A
Connect Hydraulics
B
Backing Into Field Position
1) Drive landroller onto level ground, straight behind the
tractor.
Ensure there is plenty of room behind and to the sides
•
of the landroller for backing into field position.
2) Remove all 3 red transport bars.
cylinder and 2 located on rear endwheel cylinders)
Place the transport bars into the storage positions
•
shown and secure with lock-pins.
Note: You may need to activate (slightly extend) the hydraulic
cylinders to allow removal of the cylinder transport bars.
2
3) Activate the End Wheel Circuits
Endwheel to around 20° max. Try to match the angles
on each wheel.
4) Retract the transport cylinder
until the weight of the drum is on the ground.
*
TRANSPORT / FLOAT.....................
1
LEFT HAND WHEEL ..................
2
RIGHT HAND WHEEL ................
3
(1 on front transport
.
(LH & RH)
2
1
4
& to turn each
2 3
3
20° MAX
3
20° MAX
2
to lower the center drum
1
WARRANTY
REMEMBER! You must complete Product
Registration to be eligible for Warranty.
5) Slowly back-up the landroller until wings are slightly
spread.
3
6) Turn the wheels
pushing on the sidewalls of the tires.
3
7) Backup until the wings are straight in line with the
center frame. Ensure wheels are straight before Step 8.
8) Activate the transport cylinder
Retract until all the roller drums are on the ground. Once
all drums are on ground, set transport circuit to "float"
position.
IMPORTANT:
activates the transport cylinder into "float" position. This
will allow the hitch pole to contour more effectively and
prevent strain or possible damage to the machine.
Transport Cylinder
LH Endwheel Cylinder
RH Endwheel Cylinder
& while backing up. Avoid
2 3
2
1
to retract the cylinder.
1
Set the tractor hydraulic remote that
2
142785 v1.0