Nortel BayStack 660 Use Manual page 123

Table 6-1.
SNMP commands— Use these commands to configure/display SNMP
attributes.
snmp show {community | hosts | security}
PHY command— Use these commands to configure/display wireless
PHY layer attributes.
phy add-bss-basic-rate < num_Mbps >
phy channel < channel_no >
phy delete-bss-basic-rate < num_Mbps >
phy dwell-time < num_kus >
phy hop-sequence < pattern_no >
phy show
System commands— Use these commands to configure/display
system attributes.
sys essid < ess_id_name >
sys ether-link-mode {10base_2 | 10base_t}
sys gateway < gtw_ip_addr >
sys ip-address < sys_ip_addr > < sys_net_mask >
sys ip-on-wport {enable | disable}
sys load-image < file_name > < tftpd_ip_addr >
sys name < sys_name >
sys show
WEP commands— Use these commands to configure/display Wired
Equivalent Privacy (WEP) attributes.
wep default-key < key_id >
wep exclude-unencrypt {on | off}
wep show
203939-B
CLI Command List (continued)
Command Line Interface
Go to page 6-19
Go to page 6-17
Go to page 6-20
Go to page 6-22
6-5