Jumper Locations On The Board; The 2Pin Jumpers; The 3Pin Jumpers - DIGITAL-LOGIC MICROSPACE MSEBX800 User Manual

DIGITAL-LOGIC AG
7. J
UMPER
The following tables show the location of the jumper blocks on the MSEBX800/900 board. The numbers
shown in these tables are silk screened on the board so that the pins can be easily located. This chapter
refers to the individual pins for these jumpers.
Be careful: some jumpers are soldering bridges; you will need a miniature soldering station with a vacuum
pump.
Settings written in bold are defaults!

7.1. The 2pin Jumpers

Jumper Structure
J2 LAN B (SM800DK LAN) isolate
J6 Select Video Out- or Input
J8
Disable write protection of local FWH
(FirmWareHub)
J9
Boot FWH from SM800PCX or from
the MSEBX800-Board

7.2. The 3pin Jumpers

Jumper Structure
J1 PCI X130 slot in JTAG chain
J3 LCD VDD voltage
J4
LVDS transmitter
J5 LCD Backlight voltage
J7 RTC enable / disable
1.) The 12V are only available if an ATX-Supply is connected.
2.) It's possible to connect an external RTC back-up battery to pin 2-3 of J7.
L
OCATIONS ON THE
MSEBX800/900 Detailed Manual V1.0
B
OARD
Open
Enable LAN B Disable LAN B
Enable LCD/LVDS Enable Video-In
FWH read only
FHW read / write
Boot SM800PCX
Boot local FWH
FWH
Open
JTAG w/
+3.3V
LVDS on LVDS auto on
+5V
Enable RTC batt Disable RTC batt
50
Closed
1 - 2
Closed Closed
1 - 2 2 - 3
JTAG w/o
+5V
LVDS off
1)
+12V
2)