Table of Contents
Advertisement
Electrical work
How to connect your extended power cables
1. Prepare the following tools.
Tools
Spec
Shape
2. As shown in the figure, peel off the shields from the rubber and wire of
the power cable.
- Peel off 20 mm of cable shields from the pre-installed tube.
• For information about the power cable specifications for indoor
and outdoor units, refer to the installation manual.
CAUTION
• After peeling off cable wires from the pre-installed tube, insert a
contraction tube.
3. Insert both sides of core wire of the power cable into the connection
sleeve.
f Method 1
Push the core wire into the sleeve from both sides.
f Method 2
Twist the wire cores together and push it into the sleeve.
4. Using a crimping tool, compress the two points and flip it over and compress another two points in the same
location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
16
CAC 유럽향 1way_IM_34507A-05_EN.indd 16
Connection sleeve
Crimping pliers
MH-14
20xØ6.5(HxOD)
f Method 1
Compression
Compress it 4 times.
dimension
Insulation tape
(mm)
Width 19mm
Power cable
Pre-installed tube for the power cable
f Method 2
5 mm
Contraction tube (mm)
70xØ8.0(LxOD)
20
20
20
60
120
180
(Unit: mm)
20
Connection sleeve
Connection sleeve
Compress it 4 times.
5 mm
2016-08-02 오후 4:08:12
Advertisement
Table of Contents
