Table of Contents
Advertisement
Preparation for installation
When deciding on the location of the air conditioner with the owner, the following restrictions must be taken into account.
General
Do NOT install the air conditioner in a location where it will come into contact with the following elements :
Combustible gases
Saline air
Machine oil
Sulphide gas
Special environmental conditions
If you must install the unit in such conditions, first consult your dealer.
Avoid installing the air conditioner :
In areas where it is exposed to direct sunlight. Close to heat sources.
In damp areas or locations where it could come into contact with water. (for example rooms used for laundry)
In areas where curtains and furniture could affect the supply and discharge of air.
Without leaving the required minimum space around the unit. (as shown in the drawing)
In scarcely ventilated areas.
On surfaces that are unable to support the weight of the unit without deforming, breaking or causing vibrations
during the use of the air conditioner.
In a position that does not enable the condensate drainage pipe to be correctly installed. (at the end of the
installation. It is always essential to check the efficiency of the drainage system)
Accessories
The following accessories are supplied with the indoor unit.
The type and quantity may differ depending on the specifications.
Pattern sheet A (1)
Pattern sheet B (1)
Rubber
4
CAC 유럽향 1way_IM_34507A-05_EN.indd 4
Insulation pipe (2)
Installation manual (1)
Flexible hose (1)
Insulation drain (1)
Cable-tie (3)
Installation gauge (1)
2016-08-02 오후 4:08:08
Advertisement
Table of Contents
