Arlight SR-2819SP Quick Start Manual

RF RGB Programmable Led Controller
Important: Read All Instructions Prior to Installation
Function introduction
Program: short press to start program,
LED light connected with receiver will
blink, then touch color wheel to choose
a color, then choose another color (make
sure to choose at least 2 colors,
most 7 colors), then short press the
button again to save the chosen colors,
LED light connected with receiver will
blink to indicate successful program.
Now you can use button to play the
colors with different running effects
and speeds.
1
Press and hold down to increase/
decrease light intensity of RGB
channels
Click to turn ON/OFF all zones
Click to play programmed colors
with different running effects: jump,
flash, fade, strobe. Click to switch
effects, press and hold down to
S1
speed up/down the effects.
4.5V(3xAAA battery)
09.289SP.04266
Indicator: indicate the
state of remote control
P
Color wheel
Zone numbers:Click to choose
the zone/zones, Press and hold
2 3 4
down to turn on/off corresponding
zone
W
The white channel: click to turn
on/off, Press and hold down to
increase/decrease light intensity
Click to switch CW, NW, WW
mixed by RGB
Press and hold down to save colors;
S2 S3
Click to recall the saved colors
Front side
Bottom side
Product Data
Output
RF signal
Operation Frequency
869.5/916.5/434MHz
Power Supply
4.5V(3xAAA battery)
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
120x55x17mm
Safety & Warnings
• This device contains AAA batteries that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Pair with RF receiver(Method 1)
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 5:Touch the color wheel, LED lights connected with the RF receiver flicker
P
once means the receiver is paired with zone 4 successfully.
1 2 3 4 Step 4:Choose and click a zone number(e.g. zone 4)
W
Step 2:Click ON/OFF button to activate the remote
S1 S2 S3
Step 3:Click the "Learning Key" button on RF receiver or re-power on the receiver
three times continuously to set it into pairing status
Pair with RF receiver(Method 2)
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
P
Step 4:Choose and click a zone number(e.g. zone 4) twice, then press and hold it
continuously and quickly within 10 seconds, LED lights connected with the RF receiver
1 2 3 4
flicker once means the receiver is paired with zone 4 successfully.
W
Step 2:Click ON/OFF button to activate the remote
S1 S2 S3
Step 3:Power off and power on the receiver
• Control 4 zones of RF receivers separately.
• RGBW color controller
• High sensitive & high stable, fast & precise color control.
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
RF LED Receiver
Learning Key
RF LED Receiver
Learning Key