Table of Contents
Advertisement
FIGURE 4.2:
16
Services Required
Services
4.5 SMEMA Interfacing
The system is designed in such a way, that it complies with the SMEMA
standards. With every system one SMEMA interface cable (length 200 cm)
will be delivered. If the system needs to work with equipment that is not
supplied by Philips - AAA, this equipment must comply with the SMEMA
standards. The SMEMA cables must be made in advance, according to the
drawing of fig. 4.2 and the specification given below.
Cable specification: 4 wires,
Cable connector for both ends consisting of the following parts per connector:
CPC 14p connector pin: AMP 206044-1
5-pin contacts: AMP 202236-1
cable clamp: AMP 206070-1,
Circuit diagram connector points 1 to 4 must be connected to 1 to 4.
SMEMA interfacing.
Pre-installation Manual CSM 66/84/84V III
PA 1306/40 /50 /60 /61
Required
5322 871 63303
96.00
Advertisement
Table of Contents
