Chair Assembly; Removing The Backrest; Chair Placement - Accora Configura Lite Medium Instruction Manual

Chair Assembly

The chair will be delivered with the backrest removed
as shown in fig 1.
1
1. Check that the locking clip on the back of the
chair is in the vertical position. Reposition if
necessary. A picture of the locking clip is shown in
fig 2.
2
2. Place the hand control and cable over the chair
base, then slide the back onto the base.
NOTE: Depending on chair width, you may need to
slide on one side of the back at a time. If this is the
case, level the chair-back before pressing down to
lock into position.
3. Locate the bracket on the backrest that locates
with the locking clip shown in fig 3.
3
4 © Accora Configura® assessment helpline: 01223 206110 | configura@accora.uk.com | www.configura.uk.com
4. Push firmly on the top of the back to lock into
position. You must hear a click from each side of
the chair to ensure the back is locked in properly.

Removing the Backrest

To remove the backrest, recline the chair so that the
backrest clips are visible. Raise the tongue on each
clip and pull the backrest away from the chair.
It is often easier to release one clip first, then lift the
backrest a small distance while releasing the other
clip.

Chair Placement

The chair should be placed near a standard
electrical outlet on dry, level ground where there is
ample room to allow for proper operation. It must be
place on a surface which is appropriate to take the
weight of the chair and an adequate safety margin.
We recommend that you have the assistance of an
assistant when positioning the chair to avoid the
possibility of injury when lifting.
Follow these steps to position the chair in a safe
manner:
1. Place the back of the lift chair 40cm from the
nearest obstruction while the chair is in the seated
position. This measurement may vary depending
on model.
2. Position the external transformer on the floor in an
open, well-ventilated area where it will not be an
obstruction.
3. Position the low voltage connection cable where
it will not be pinched between the frame and the
lift mechanism.
4. Connect the low voltage connection cable to the
external transformer if it is not already connected.
5. Plug the power cord directly into the electrical
outlet. Do not use an extension cord!