Weider 6900 User Manual page 18

28. Wrap the High Cable (55) under a Thick
Pulley (48).
Attach the Thick Pulley (48), a Cable Trap (50),
and two Half Guards (43) to the upper hole in
the U-bracket (45) with an M10 x 50mm Bolt (66)
and an M10 Locknut (56).
Make sure that the Cable Trap (50) is oriented
to hold the High Cable (55) in the groove of
the Thick Pulley (48) and that the Half Guards
(43) are on the outside of the U-bracket (45).
29. Route the High Cable (55) upward through the
Top Frame (4) and over a Thin Pulley (47).
Attach the Thin Pulley (47) inside the Top Frame
(4) with the M10 x 68mm Bolt (71) used in
step 27, a 10mm Spacer (86), an M10 Washer
(57), and an M10 Locknut (56).
30. Route the High Cable (55) over a Thick Pulley
(48) and downward through the Top Frame (4).
Attach the Thick Pulley (48) inside the Top
Frame (4) with an M10 x 68mm Bolt (71), two
M10 Washers (57), two 13mm Spacers (52), and
an M10 Locknut (56).
28
29
30
56
4
18
55
48
56
50
43
45
43
55
47
4
56
57
86
71
48
57
52
55
52
57
66
71