Erase - Bay Networks 5399 Hardware Installation Manual

erase

The erase command erases the contents of non-volatile memory
(EEPROM memory). Erasing EEPROM restores all parameters to
factory default values. The syntax is:
erase
The erase command prompts for confirmation before erasing the non-
volatile (EEPROM) memory.
The erase command does not erase the Ethernet address.
Since the erase command erases the IP address, you may need
to use the addr command to re-enter the Remote Access
Concentrator's IP address before reloading any software (if you
are using BOOTP or RARP, you should not set the IP address).
The
erase
monitor:: erase
Erase all non-volatile EEPROM memory? (y/n) [n]:: y
Erasing <65504 or 8160 bytes> of non-volatile memory.
Please wait...
.........................................
.........................................
.........................................
.........................................
Initialized checksum record installed
.
.
.
Model 5399 Remote Access Concentrator Module Hardware Installation Guide
command display looks like this:
Chapter 3 ROM Monitor Commands
16K->|Data 0x0
3-15