Table 4. Summary of installation tasks (continued)
Task
number
10
13
Installation precautions
Follow these precautions when installing the unit.
Attention:
"Safety notices" on page xi.
Attention:
ambient temperature might exceed 40° C (104° F).
Attention:
is not restricted.
Attention:
Lifting precautions
See "Rack safety" on page xviii before installing this product in a rack.
Power precautions
Attention:
insert the supply upside down, although the supply will not engage with the power
backplane when upside down.
Attention:
remove it from the device. Otherwise, the power supply or the device could be
damaged as a result. (The device can be running while a power supply is being
installed or removed, but the power supply itself should not be connected to a
power source.)
Attention:
switches. The power supply produces extensive power. Installing the power supply
in a device other than the c-series switches will cause extensive damage to your
equipment.
Attention:
you disconnect the power supply from AC power before installing or removing the
supply. The device can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power source.
Otherwise, you could be injured or the power supply or other parts of the device
could be damaged.
Task
Once you power on the device and
assign IP addresses, the system is
ready to accept network equipment.
Secure access to the device.
Before starting any installation or maintenance procedure, refer to
Do not install the device in an environment where the operating
Make sure the air flow around the front, sides, and back of the device
Never leave tools inside the chassis.
Make sure you insert the power supply right-side up. It is possible to
Remove the power cord from a power supply before you install it in or
The power supply is designed exclusively for use with the c-series
Power supplies are hot swappable. However, It is recommended that
Where to find more information
Chapter 4, "Connecting a c-series
switch to a network device," on page
23
Configuration Guide
Chapter 3. Installation
11