Table of Contents
Advertisement
When you establish the serial connection to the system, press Enter to display the
CLI prompt in the terminal emulation window. For example:
v NetIron >
If you see this prompt, you are now connected to the system and can proceed to
"Assigning permanent passwords" on page 23.
You can customize the prompt by changing the system name. See the
Configuration Guide.
If you do not see one of these prompts:
1. Make sure the cable is securely connected to your PC and to the system.
2. Check the settings in your terminal emulation program. In addition to the
The EIA/TIA 232 serial communication port serves as a connection point for
management by a PC or SNMP workstation.
22
IBM Ethernet Switch c-series Installation and User Guide
v Flow control: None
session settings listed above, make sure the terminal emulation session is
running on the same serial port you attached to the system.
Advertisement
Table of Contents
