Caller Id; Contact Id - DIGITIZE DDI-9E Installation And Operation Manual

DDI-9E INSTALLATION AND OPERATION MANUAL
If an abnormal condition occurs (i.e. the dialer is reset and no restoral will be received)
the operator may also clear the condition as follows: While the dialer message
is on the display, press DIALER LOOK UP. While the display reads "DD
xxx-x pg. 1", press CLEAR to remove the dialer Alarm or Trouble
condition.

1.1 CALLER ID

All DDI-9E units are equipped with Caller ID.
subscribes to Caller ID, the following information is printed after the first ring is received
and the DDI-9E processes the data.
If the Caller ID information is being blocked by the calling party, the following
information will print:
If the calling party is out of the Caller ID service area, the following information will be
printed:
Information regarding Caller ID availability in your area can be obtained from your local
telephone carrier.

1.2 CONTACT ID

The Contact ID account number will be a nine-digit number. For example, 123401008,
where 1234 is the account number, 01 is the Group number and 008 is the
zone/contact/point, etc. number.
Leading zeros will be left blank. For example, on account 234 the Contact ID account
number may be 23401008.
When adding an account number to the SYSTEM 3500/3000, you can assign it to any
group (i.e. 1 –8). The group fields are not used when receiving a Contact ID account. If
an existing 3x1, 4x2 etc. account switches to Contact ID, you only need to program the
user text messages for the new account numbers. Note: You can use WIN3000 to simply
renumber the account and use the same message.
When a Contact ID account appears on the display, you will get the Contact ID info as
the first screen. Both zone specific and generic messages will work with the Contact ID.
DIGITIZE, INC 700236-0001 REV. A
CALL ID - Area Code -Phone Number
Date - Time
CALL ID - Blocked
Date- Time
CALL ID - Out of Area
Date - Time
If the Alarm monitoring location
1-2