Section 2. Cleaner Specifications; General Specifications; Assemble The Charging Station - Polaris FREEDOM EB37 Series Owner's Manual

Cordless robotic cleaner
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH

Section 2. Cleaner Specifications

2.1

General Specifications

The general specifications for the cleaner are as
follows:
WARNING
Only use the battery charger supplied with the cleaner.
Charging Station Supply
Voltage
Supply Voltage
Battery Capacity
Operating Power
Cleaner Size (WxDxH)
Weight of Cleaner
Packed Weight
Filtration
Cycle Lengths
Charge Temperature
Water Temperature
Range
Operating Depth
The cleaner is a double-insulated product.
A double-insulated electrical appliance is one which
has been designed in such a way that it does not
require a safety connection to ground. The basic
requirement for double-insulation is that no single
failure can result in dangerous voltage becoming
exposed so that it might cause an electric shock
and that this is achieved without relying on an
earthed (grounded) metal casing. This is achieved
by having two (2) layers of insulating material
surrounding live parts or by using reinforced
insulation. Therefore, devices having double-
insulated construction, such as this cleaner,
do not use a grounded (three-prong) cord/plug.
Page 6
110-240 VAC; 50/60 Hz
29.4 V DC
9.6 Ah
58 W
16 x 16.5 x 11 inches
(41 x 42 x 28 cm)
20 lbs. (9.1 kg)
33 lbs. (15.5 kg)
All-purpose filter canister
Variable programming
Max 104°F (40°C)
Min 40°F (5°C)
Max 95°F (35°C)
Min 55°F (13°C)
Max 13 ft. (4 m)
Min 15 in. (40 cm)
Polaris
FREEDOM
®
2.2
Contents
The packaging should contain the following items:
• Polaris Cleaner
• Charging Station
• Removal Hook
Figure 1.
Contents
2.3

Assemble the Charging Station

1.
Insert the top of the charging station foot
(marked with a blue dot) into the top rear of
the charging station (also marked with a blue
dot). Push the lower part of the foot into the
lower cavity of the charging station until clip
is secure.
2.
Attach the hook clip to either charging station
foot. Attach the hook to the clip.
3.
Run cable through either foot cable slot.
Cable slots
Figure 2.
Assemble Charging Station
Cordless Robotic Cleaner | Owner's Manual

Advertisement

Table of Contents
loading

Table of Contents