Cleaner Error Codes - Polaris FREEDOM EB37 Series Owner's Manual

ENGLISH
7.3

Cleaner Error Codes

On/
Blinking Red
Off
Page 20
Display in the
iAquaLink ® App
Safety Shut-off • The cleaner is in safe state.
• The cleaner board is under power but does not
Communication
error
• Contact your retailer for a diagnostic review or
Traction motor • Check that debris is not preventing the brushes
right
• Rotate each wheel by a quarter of a turn in the
Traction motor left
Drive motor
consumption right
• Contact your retailer for a diagnostic review or
Drive motor
consumption left
Cleaner out of the • Thoroughly clean the filter canister.
water
• Restart the cycle, then submerge cleaner in the
• Contact your retailer for a diagnostic review or
Pump motor • Turn off the cleaner using the slider by sliding to
• Check for small debris or hair in the fan impeller.
• Thoroughly clean the filter canister.
• Contact your retailer for a diagnostic review or
Firmware Update • Close the iAquaLink
Error
• Check that the cleaner is connected to the
• If the indicatoris not steady, open the
Polaris FREEDOM Cordless Robotic Cleaner | Owner's Manual
® ™
Solutions
respond.
contact Technical Support at 1.800.822.7933.
or tracks from moving freely.
same direction until it rotates smoothly. Repeat
turning wheels in the opposite direction until
rotation is smooth.
contact Technical Support at 1.800.822.7933.
water and shake to release air bubbles.
contact Technical Support at 1.800.822.7933.
the left and hold for 20 seconds while off of the
charging station. No LEDs will be illuminated.
contact Technical Support at 1.800.822.7933.
® app.
Wi-Fi network (the LED is solid blue).
iAquaLink™ app, select the cleaner and click
on "Update".