Install And Submerge The Cleaner; Removal - Polaris FREEDOM EB37 Series Owner's Manual

ENGLISH
NOTE: Choose Floor Only mode to clean with Pool
Cover on. Additional cleaning modes may be
available in the App.
3.3

Install and Submerge the Cleaner

1. Start the cleaner using the slider by sliding and
releasing to the right or use the App.
Figure 8. Slide and Release Right to Start
2. The cleaner does not begin moving until it
senses water. A blinking blue LED light means
it is ready to clean.
3. At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside.
1
Figure 9. Submerge the Cleaner Vertically
Page 10
Polaris FREEDOM
® ™
4. Wait for bubbles to stop completely, then let
the cleaner sink to the bottom of the pool.
2
Figure 10. Cleaner Sinking to the Bottom of the Pool
5. Cleaning cycle will start as soon as the cleaner
detects the pool floor.
WARNING
Do not enter pool while the robotic cleaner is in water.
3.4

Removal

3.4.1 Manual Retrieval
1. Attach the hook (stored on the charging
station) to a standard pool cleaning pole (not
included).
Figure 11. Removal Hook
2. Secure the hook on the cleaner handle. Bring
the cleaner to the waterline.
Cordless Robotic Cleaner | Owner's Manual