Table of Contents
Advertisement
13. Maintenance
13.1 Definition of Maintenance Terms
Term
Action Required
Adjust
Correct to defined limits
Change
Remove the original and fit a new or overhauled part or assembly in its place
Check
Determine a particular nominated condition before, during orafter repair e.g. completeness,
security, position
Clean
Remove all dirt and deposits
Defective
Any fault or faults in a component or assembly, e.g. structural fractures or weld fractures, which
may prevent the component or assembly from fulfilling its designed purpose
Dismantle
Take to pieces
Examine
Determine general condition before repair e.g. wear, cracks, splits, leaks, scoring, erosion,
breaks, distortion, looseness
Gauge
Measure. Note 'gauge' can also mean inside of rail
Inspect
Determine general condition after repair and attention i.e. conformity to required standards
Lubricate
Apply lubrication
Overhaul
Do what is necessary to make an assembly or sub-assembly re-usable i.e. dismantle, strip,
clean, examine, fit new parts, re-assembly, test and inspect as required
Paint
To impart colour to a surface
Re-assemble
Put together
Record
Put down in writing a finding from examination, test, inspection or special checks
Rectify
To set right
Refit
Put back and re-connect
Replace
Remove, scrap original part and put new part in its place.
Remove
Disconnect and take off
Repair
Restore an original part to the required condition by hand tooling, machining, build-up, welding,
patching, bending, setting, heat-treating, re-securing etc.
NOTE!
Any type of repair work must be carried out by Pandrol own personnel.
Strip
Remove covering, i.e. paint, polish, fabric
Test
Prove correct operation by trial
Report
Convey to the Maintenance Supervisor the condition of the item examined.
OPERATION AND MAINTENANCE MANUAL I ENG_OMM_CD200IQ_P03 I 11 February 2022
@Pandrol 2022
65 av 118
Advertisement
Table of Contents
