Programming Radio Transmitter; Pairing Handheld Transmitter; Changing The Direction Of Rotation Of The Radio Motor; Pairing Another Handheld Transmitter - 3T-Components 3T-MOTORS 3T45-10R Installation & Operating Instructions Manual

PROGRAMMING RADIO TRANSMITTER

Important when teaching, changing or deleting transmitters:
Only one relevant motor may be switched to voltage!
Several radio motors or radio receivers can be programmed to form a group with the same transmission channel.
For multi-channel transmitters, channel by channel must be taught or transferred.
Pairing handheld transmitters
with Radio motor Type R:
Long beep
from motor
Switch on power supply.
Only switch the affected receiver
to voltage.
Change direction of rotation
of radio motor:
Long beep
from motor
Switch on power supply.
Only switch the affected receiver
to voltage.
Pairing another handheld
transmitter:
Leave Power supply
switched on.
Leave voltage of all motors
switched on.
Beep while
pressing
2 x Press button P2 / Set Up
Beep while
pressing
2 x Press button P2 / Set Up
Beep while
pressing
2 x Press button P2 / Set Up
of the already paired
handheld transmitter
After switching on the power supply, programming (pressing the buttons) must be
carried out within 10 seconds. Otherwise the motor returns to its original state.
1 x Press Up-button
After switching on the power supply, programming (pressing the buttons) must be
carried out within 10 seconds. Otherwise the motor returns to its original state.
1 x Press Down-button
After switching on the power supply, programming (pressing the buttons) must be
carried out within 10 seconds. Otherwise the receiver returns to its original state.
1 x Press button P2 / Set Up
of the new
handheld transmitter
OK
The motor confirms
the programming
OK
The motor confirms
the programming
OK
The motor confirms
the programming
3T-MOTORS Radio tubular motors | Programming radio transmitter
with several
beeps
with several
beeps
with several
beeps
16