Advertisement
The Survey Pro CE software will allow the user to Append the Description after the point
has been stored. This featured can be turned off if desired.
Tap OK, or hit Enter on the Ranger keyboard to accept the Descriptor. If desired, Tap on
the Attributes... button to store additional information related to the description.
If finished collecting Topographic data, return to the Survey Pro CE Main menu...
GPS Staking
Note: to perform any Stakeout functions, the Stake-out Point's: Point Number, Northing,
Easting, Elevation and Descriptions MUST be Pre-loaded into the Ranger, before any
stake out work can be started. Typically, these coordinates are pre-loaded into the Ranger
back at the office.
The Customer may have calculated these coordinates with a COGO software, or the
coordinates may have been generated from a design, or drawing file.
The coordinates for Control Points and the Design (Stake-Out) points MUST be on the
same coordinate system. That is, the points used on the job site for the Localization
MUST be on the same coordinate system as the Design Points.
You cannot perform a TDS Localization based on N-5000, E-5000, Elev-500m and then
Stake out points that have State Plane NAD 83 coordinates.
There is no established physical relationship between these two coordinate systems.
Thales Navigation: ZXSS-TDS v3.2.1 Localization
30
Advertisement
