2. Conformity 4.6 System Description ......................3 This guide is published by 3Shape TRIOS A/S, who reserves the right to improve 4.7 TRIOS Scanner, TRIOS Scanner Tip and TRIOS Protection Tip Description ....4 and modify the contents without prior notice. Modifications will, however, be published 4.8 Battery and Battery Charger Description ...............4...
Standby 4.2 Intended Use L1P-1: The 3Shape TRIOS system is intended to obtain 3D digital images of the topographical Refer to instruction manual / booklet. Follow instructions for use characteristics of teeth, including bite, gingivae and palate directly from the patient’s mouth or models of the teeth.
If any other charging pattern appears, a charging error has occurred. In this case, remove the batteries from the charger and reinsert them. If charging errors continue, please contact 3Shape 4.8 Battery and Battery Charger Description support (support@3shape.com). A set of batteries for the TRIOS scanner (TB-04): Batteries for the TRIOS scanner with LED light There is an LED under the battery charger.
Relative humidity: 10 – 85 % (non-condensing) Step 1: Turn the PC on. Atmospheric pressure: 800 – 1100 hPa Start 3Shape software. Transport Conditions Ambient temperature range: -10 – +50 °C (+14 – +122 °F) Step 2: Log on using a default TRIOS Operator.
4.16 Declaration – Electromagnetic Emissions Electromagnetic environment – guidelines Portable and mobile RF communications equipment should be used no closer to any The TRIOS system complies with the requirements EN/(IEC) 60601-1-2 (Edition 4.0) part of the TRIOS system, including cables, than the recommended separation distance clause 7 Emissions.
TRIOS scanner and the TRIOS software. The communication between TRIOS Scanner and TRIOS software is handled by 3Shape communication services. Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
5.4 Electrical Safety 5.6 Hygiene For instructions on how to mount the single-use sleeve see the TRIOS Sleeve instructions for use. Do not access the inside of any part of the system For instructions on cleaning and disinfection or sterilization go to section 7. WARNING Always wear gloves There is a risk of electrical shock if you attempt to access the inside of any...
5.8 Epileptic Seizure Cleaning/disinfectant wipes containing Isopropanol (17.2%) and Ammonium Chloride WARNING e.g. CaviWipes. There is a risk of injuries if the scanner tip is bitten. As a direct effect of an epileptic seizure, various degrees of involuntary biting can occur. Avoid any patient biting on the scanner tip or bumping the scanner tip into the teeth.
Dispose of the CaviWipe. Wipe the surface of the metal holder to remove any gross contaminants. Dispose of the CaviWipe. Step 4: Disinfect Take a CaviWipe. Step 4: Disinfect rubber insert Wet the surface of the TRIOS scanner body and Take another CaviWipe.
For general cleaning, apply a mild detergent to a soft, damp cloth. In case of any serious incident that has occurred in relation to the use of the device, please report the incident to 3Shape at email: support@3shape.com and you can also report it CAUTION to the competent authority of the state in which the user and/or patient is established.
Page 12
Let’s change dentistry together 3Shape TRIOS A/S Holmens Kanal 7 1060 Copenhagen Denmark More information at 3Shape.com...
Need help?
Do you have a question about the TRIOS 5 and is the answer not in the manual?
Questions and answers