Advertisement
Service Steps Reassembly
Power Tools and Industrial Lifting - Customer Technical Service
Insert Air Port Assembly into air port(s) inside Motor Housing.
Installation of End Plate bearings:
Pack Bearing races with grease and use aan Arbor press or
equivalent to press Bearing(s) into End Plate(s).
When pressing a bearing into a recess, press on the outer race.
Note: When pressing a bearing onto a shaft, press on its inner
race
Using a long T hex wrench as an alignment pin, align Dowel
Hole(s) in End Plate and Cylinder with the Dowel Hole in the
bottom of the motor bore.
TL-xxxxxx
Advertisement
