Advertisement
Hardware Preparation and Installation
1
Preparing the Board
MVME162P4 Configuration
Function
VME System Controller (J1) on page 1-7
IP Bus Clock (J14) on page 1-7
SIM Selection for Serial Port B (J15) on page 1-8
Serial Port 1/Console Clock (J16) on page 1-11
1-4
To produce the desired configuration and ensure proper operation of the
MVME162P4, you may need to reconfigure hardware to some extent
before installing the module.
Most options on the MVME162P4 are under software control: By setting
bits in control registers after installing the module in a system, you can
modify its configuration. (The MVME162P4 registers are described in
Chapter 3 under ENV – Set Environment, and/or in the MVME1x2P4 VME
Embedded Controller Programmer's Reference Guide as listed in "Related
Documentation" in Appendix E.)
Some options, though, are not software-programmable. Such options are
either set by configuration switches or are controlled through physical
installation or removal of header jumpers or interface modules on the base
board.
Figure 1-1
illustrates the placement of the jumper headers, connectors,
configuration switches, and various other components on the
MVME162P4. Manually configurable jumper headers and configuration
switches on the MVME162P4 are listed in the following table.
Note
Jumper J3 is not listed, as it is provided for manufacturing
purposes only and cannot be configured.
Table 1-2. MVME162P4 Configuration Settings
Factory Default
SIMM06
No jumpers
Computer Group Literature Center Web Site
2-3
1-2
Advertisement
