Advertisement
1Hardware Preparation and
Introduction
This chapter provides unpacking instructions, hardware preparation
guidelines, and installation instructions for the MVME162P4 VME
Embedded Controller. Hardware preparation of the MVME712 series
transition modules compatible with this board is described in separate
manuals.
Getting Started
This section supplies an overview of startup procedures applicable to the
MVME162P4. Equipment requirements, directions for unpacking, and
ESD precautions that you should take complete the section.
Overview of Installation Procedure
The following table lists the things you will need to do to use this board
and tells where to find the information you need to perform each step. Be
sure to read this entire chapter, including all Cautions and Warnings,
before you begin.
What you need to do...
Unpack the hardware.
Reconfigure jumpers or switches on the
MVME162P4 board as necessary.
Ensure that IP modules are properly
installed on the MVME162P4 board.
Install the MVME162P4 board in a
chassis.
Connect a display terminal.
Table 1-1. Startup Overview
Refer to...
Guidelines for Unpacking on page 1-2
Preparing the Board on page
IP Installation on the MVME162P4 on page
1-21.
MVME162P4 Installation on page
Serial Connections on page
Installation
1-4.
1-26.
1
1-22.
1-1
Advertisement
