S7 Connection Completion Timeout; S8 Comma Dial Modifier Time; S10 Automatic Disconnect Delay; S12 Escape Guard Time - Nokia 8210 Command List

S7 Connection Completion Timeout

S8 Comma Dial Modifier Time

S10 Automatic Disconnect Delay

S12 Escape Guard Time

S25 Detect DTR Change Time

S47 Force Fax Class 2/2.0 Error Correction Mode

AT Command Set for Nokia 8210
Also known as 'no answer timeout'. Value is given in seconds. Value 0 (unlimited
time) is not in V.25ter. (V.25ter section 6.3.10).
Syntax:
ATS7=<n>
ATS7?
Value is given in seconds. See also command D, page 46. (V.25ter section 6.3.11. )
Syntax:
ATS8=<n>
ATS8?
Value is given in tenths of a second. Values 0 and 255 (do not disconnect) are not in
V.25ter. (V.25ter section 6.3.12.)
Syntax:
ATS10=<n>
ATS10?
Value is in fiftieths of a second (default is one second). See also the command +++
Escape at page 10. (De facto.)
Syntax:
ATS12=<n>
ATS12?
Time (in seconds) to react on DTR signal change. See also command &D, page 9.
(De facto.)
Syntax:
ATS25=<n>
ATS25?
Values for <n>:
000
...
255
Error Correction Mode can be enabled using this register. 0=disabled, 1=enabled
with 64 byte frames, 2=enabled with 256 byte frames.
Syntax:
ATS47=<n>
ATS47?
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Values for <n> are 0..255 (default 60).
Query current setting.
Response is <n>.
Values for <n> are 0..255 (default 2).
Query current setting.
Response is <n>.
Values for <n> are 0..255 (default 100).
Query current setting.
Response is <n>.
Values for <n> are 0..255 (default 50).
Query current setting.
Response is <n>.
Set DTR change time. Default is 0.
Show valid values. Response is <n>.
Values for <n>: 0..2 (default 0)
Response is <n>. Values for <n>:
000..002
51