Attaching The Labels - Canon Unit-BF1 Service Manual

4
16 17
16) Install the finisher rear 17)Install the finisher rear
cover using four screws.
middle cover.

Attaching the Labels

1
1) Raise the puncher unit.
Affix the supplied labels at the positions shown below.
- Peel the label from the separator on which "A" is printed, and then affix it to the cover in the finisher.
- Affix the label printed in the user specified language under the puncher unit.
4
18 19
19) Install the supplied punch waste paper box.
18) Install the inner upper
cover using two screws.
F-4-19 F-4-19
2
2) Close the front door of
the finisher.
F-4-20 F-4-20
4-8
20
20) The following parts will be no longer
needed once the puncher unit has been
installed.
Two screws (RS-tight, M4 x 6)
•
•
Magnet plate
Punch unit fixing pin (for saddle finisher)
•
Three screws (TP, M3 x 6)
•
•
Feed unit
4-8