Table of Contents
Advertisement
3
4) Remove the punch controller PCB connector (CN4) and
remove the punch waste full sensor cable from the cable
guide.
x1
x4
6) Pull out the punch unit cable connector.
x1
3
F-3-4
F-3-4
5) Remove the 2 finisher controller PCB connectors (CN127, CN128). Remove the punch unit cable from 7
locations of the cable guide and remove the reuse band.
x2
x7
F-3-6
F-3-6
3-3
F-3-5
F-3-5
3-3
Advertisement
Table of Contents
