Table of Contents
Advertisement
4
5
5) Remove four screws, and then remove the finisher rear cover.
x4
7
7) Remove two screws, and then remove the magnet plate. (The magnet plate/the
two screws are no longer required.)
x2
4
6
6) Disconnect one connector, remove three screws, and remove the feed unit. (The feed unit/the three screws are no longer
required.)
x3
x1
F-4-7
F-4-7
F-4-9
F-4-9
4-4
F-4-8
F-4-8
4-4
Advertisement
Table of Contents
