TANTUM BASIC / TANTUM MLS IMPORTANT INSTRUCTIONS • Before mounting the lock, please read the instructions for use carefully. • Ensure that you only program the lock when the safe is open. After changing the code, always try the code several times with the safe door open.
Page 3
A signal will sound every 10 seconds as long as the lock is open in case “Push to Close” is active. Three long tones will sound when during opening or closing the lock bolt is blocked. Entering the code again will close, respectively open the lock again. Remove the obstruction and retry. www.m-locks.com...
The certification of this lock is based on this mounting instruction. Read carefully. The force applied to the lock bolt should not exceed 1 kN. If higher force is applied, please consult with the manufacturer / certificate holder (M-LOCKS). Only use supplied screws (M6) to mount the lock. Tightening torque 4,5 Nm.
Mount the entry unit following the manufacturer’s instruction. 1. Battery- or Alarm box 2. Keypad cable 3. Door/bolt work switch (NC) Insert the connector of the entry unit in in position 2 and check that the connector is completely seated. www.m-locks.com...
FUNCTIONAL TEST As with all locks from M-LOCKS, this unit has a unique feature for checking the electronics (both that of the input unit and that of the lock): ’Function 5’. Press and hold key ‘5’ until you hear a double tone. The LED will illuminate when performing the following actions: Next, press all of the keys in one by one and one after the other.
• During the movement of the bolt work the cables should be clear of moving parts. Only after several positive function tests (opening / closing) the safe door can be closed! DATASHEET Tantum Basic / Tantum MLS Tantum Basic anti drill Tantum MLS anti drill Opening Automatic Automatic...
Page 8
M-LOCKS BV Vlijtstraat 40 7005 BN Doetinchem The Netherlands If you need some help, please send an E-mail to: service@m-locks.com We will be happy to help you!