Huawei iSitePower-M MAP05A1 Quick Manual page 19

6.6 Installing Battery Module Signal Cables
When a communications terminal is connected to a single network cable, a waterproof rubber
plug must be installed.
1. Remove the waterproof gland from the communications terminal of a battery module.
2. Remove the locking cap and waterproof rubber plug from the communications terminal housing.
3. Install a communications cable for the battery module.
4. Lock the communications terminal waterproof gland.
5. Reinstall the waterproof rubber plug.
6. Tighten the locking cap and secure the signal cable using cable clips.
7. Install communications cables for other battery modules in sequence.
Standard Scenario
Waterproof rubber
plug
Locking cap
Unused waterproof rubber plugs
and holes need to be sealed.
18
Waterproof gland