Ab Tandard Rfid Command Able; Table 7-2: Abx Standard Rfid Command Table - EMS COBALT C0405 Series Operator's Manual

7.2 AB
X
The table below lists the ABx Standard RFID commands supported by C0405-Series
RFID Controllers.
C O M M A N D I D
0x04
0x05
0x06
0x07
0x08
0x0D
0x0E
0x0F
0x35
0x36
0x37
0x38
NOTE:
For a full description of ABx Standard RFID commands, see publication ABx Standard
Protocol – Reference Manual, available online at www.ems-rfid.com.
C 0 4 0 5 - X X X - 0 1 O P E R A T O R ' S M A N U A L – R E V . 0 3
C H A P T E R 7 : R F I D C O M M A N D S A N D E R R O R C O D E S
S RFID C
TANDARD
C O M M A N D N A M E
RFID Tag Commands
F i l l T a g
R e a d D a t a
W r i t e D a t a
R e a d T a g I D
T a g S e a r c h
S t a r t C o n t i n u o u s
R e a d
R e a d T a g I D a n d
D a t a
S t a r t C o n t i n u o u s
R e a d T a g I D a n d
D a t a
RFID Controller Commands
R e s e t C o n t r o l l e r
S e t C o n t r o l l e r
C o n f i g u r a t i o n
G e t C o n t r o l l e r
C o n f i g u r a t i o n
G e t C o n t r o l l e r I n f o

Table 7-2: ABx Standard RFID Command Table

T
OMMAND ABLE
D E S C R I P T I O N
Fills a specified tag address range
with a one-byte value
Reads a specified number of bytes
from a contiguous (sequential) length
of tag memory
Writes a specified number of bytes to
a contiguous length of tag memory
Retrieves a tag's unique
identification (Tag ID) number
Instructs the controller to search for
a tag in its RF field
Instructs the controller to start and
stop Continuous Read mode.
Retrieves the tag ID and a specified
number of bytes from the tag
Instructs the controller to start and
stop Continuous Read Tag ID and
Data mode.
Resets power to the controller
Used to modify and update the
configuration settings of the
controller
Retrieves configuration settings from
the controller
Retrieves hardware, firmware and
serial number information from the
controller
P A G E 6 5 O F 7 5